Caractéristiques et fonctions des différents types de machines de moulage par injection.

En parlant depresses à injecter, on peut supposer que la plupart des gens ne devraient pas se sentir très inconnus. En fait, la machine dite de moulage par injection peut également être appelée machine d'injection. C'est le principal équipement de moulage qui utilise des moules de moulage en plastique pour fabriquer des produits en plastique de différentes formes. Il peut être divisé en de nombreuses catégories différentes selon la méthode de plastification, la méthode de transmission de la machine et la méthode de fonctionnement. Afin d'aider les utilisateurs à mieux utiliser la valeur depresses à injecter, Tongjia Heavy Industries, a professional manufacturer of presses à injecter, will introduce the characteristics and scope of application of different types of presses à injecter in detail.
Le premier type : presse à injecter horizontale
This is a relatively common type of machine de moulage par injection. The clamping part and the injection part are on the same horizontal center line, and the mold is opened in the horizontal direction. Its characteristics are: the body is short, easy to operate and maintain; the machine has a low center of gravity, and the installation is relatively stable; after the product is ejected, it can automatically fall by gravity, and it is easy to realize fully automatic operation. At present, most of the presses à injecter on the market adopt this type.

Le deuxième type : verticalmachine de moulage par injection

In this type of machine de moulage par injection, the clamping part and the injection part are on the same vertical centerline, and the mold is opened in the vertical direction. Therefore, it occupies a small area, it is easy to place inserts, it is convenient to load and unload molds, and the materials falling from the hopper can be plasticized more uniformly. However, the product is not easy to automatically fall after being ejected, and must be removed by hand, which is not easy to realize automatic operation. Vertical presses à injecter are suitable for small presses à injecter. Generally, presses à injecter below 60 grams are more commonly used, and large and medium-sized machines are not suitable.

The third type: Angle machine de moulage par injection

The injection direction of the angle machine de moulage par injection is on the same surface as the mold interface. It is particularly suitable for processing flat products where gate marks are not allowed in the machining center. It occupies a smaller area than a horizontal machine de moulage par injection, but the inserts placed in the mold are easy to tilt and fall. This type of machine de moulage par injection is suitable for small machines.

The fourth type: multi-mode turntable machine de moulage par injection

C'est une spécialemachine de moulage par injection with multi-station operation. Its characteristic is that the mold clamping device adopts a turntable structure, and the mold rotates around the shaft. This type of machine de moulage par injection gives full play to the plasticizing capacity of the injection device, which can shorten the production cycle and increase the production capacity of the machine.